Meraki Ap Bad Ip Assignment Configuration Definition

To configure a static IP address via Dashboard, go to Switch > Monitor > Switches, select the appropriate switch, and click the pencil icon next to LAN IP:


Local IP Assignment 

  1. Connect a client to the MS. The local status page can be accessed via any ethernet port on the device.
  2. Once you have obtained an IP address, browse to the url switch.meraki.com.
  3. On this page, click Uplink Configuration.
  4. The page should now prompt for login credentials. If local login credentials were configured via Dashboard, please use these credentials. Otherwise, the default login is the device's serial number as the username and a blank password.  
    Each device is labeled with its serial number on the bottom label.
  5. On the Uplink Configuration page, set the needed connection information.

Switch to server? If you have more than one computer on your network that accesses internet then you must have a router. Unless some aspect of the server handles this. Depending on the router you have or will have for VLANS, they will be called differently. I use HP procurve switches and Cisco routers. This is my cheat sheet.

Untagged=Access=One VLAN

Tagged=Trunk=Multiple VLANS

There is also on a Cisco router/ w built in switch two sides of the VLAN world. There is 802.11q for the router sub-interfaces and there is A VLAN database for the switch ports. Can be confusing but it isn't that bad once you wrap your head around it. 

cisco example

switchport example

interface FastEthernet0/3/0

description outside

switchport access vlan 2

bandwidth 30000

no ip address

no cdp enable

vlan for switchport example

interface Vlan2

description Internet Connection

bandwidth 30000

ip address 10.1.1.1 255.255.255.0

ip nbar protocol-discovery

ip flow ingress

ip flow egress

router subinterface for vlan example

interface GigabitEthernet0/1.20

description ZOO VLAN 20

encapsulation dot1Q 20

ip address 10.10.20.1 255.255.255.0

0

0 thoughts on “Meraki Ap Bad Ip Assignment Configuration Definition”

    -->

Leave a Comment

Your email address will not be published. Required fields are marked *